Previous photo Next photo Thumbnail page
Top index page » ATX Power Supply
Ok, now that we know where everything is going its time to get out the soldering iron. After connecting the LED and splicing the brown and orange wires I started on the post. After a couple of tries I decided there had to be an easier way. Molex to the rescue! I pulled the individual connectors from a couple of old female plugs. If you never taken these out the trick is the two little ears on each connector. The trick is to push these in a little so it can slide out. They make a tool for this but you can also use anything small enough to get to the bottom of the connector. A jewelers screwdriver works great and so does the tip of your X-acto knife. Gently pull on the wire while you are pushing each ear, one at a time, until the whole thing slip right out.
Click to show/hide keyboard shortcut help
Keyboard shortcuts are active:

RIGHT arrow - next page
LEFT arrow - previous page
Page Up - index page
HOME - first page
END - last page
ESC,S,s - toggle start/stop slide show
ExhibitPlus ps54

ps48 post ps44 Post2 ps50-2 ps54 ps58 ps59 ps60 ps62
First page Previous page Index page Next page Last page



www.000webhost.com