Previous photo Next photo Thumbnail page
Top index page » Korrii Cam
The next step is to make the contacts for the inside of the cap. I did this using a spring from a ball point pen. After cutting the end off of the spring I cut two pieces about 1/8 of an inch long. I then soldered my wires to the spring.
Click to show/hide keyboard shortcut help
Keyboard shortcuts are active:

RIGHT arrow - next page
LEFT arrow - previous page
Page Up - index page
HOME - first page
END - last page
ESC,S,s - toggle start/stop slide show
ExhibitPlus cam42

cam15 cam17 cam13 cam14 cam12 cam42 cam33 cam43 cam45 cam44
First page Previous page Index page Next page Last page



www.000webhost.com